I am working on a new development platform manufactured by our
organisation. We are using the Intel PXA270 processor and the reference
BSP that I am using is MainstoneII.
At present I have been able to port the EBOOT to this new board with

I am working on Intel PXA270 processor on a new development platform
manufactured by our organisation,with MainstoneII as the reference BSP.
I have ported the EBOOT on this new board.
I want to write the NK.bin (CE image) to the Flash and using the EBOOT

Sir
 Touch Screen ADC convertor gives a 12 bit value for X and Y coordinate.
Q1. When i keep pressing at the same place of the screen the coordinates
generated are not exactly same (almost same) e.g.

      I am writing a ethernet debug library on cepc and want to access
hardware after OEMInit is called - in which "InitKitlNIC" function is
responsible for intializing ethernet hardware..
       I will be  using I/o mapped I/O address(since its x86 we have

Sir
In ddsiTouchPanelGetPoint()  When pen is down, i send (x,y) and return
TouchSampleValidFlag|TouchSampleDownFlag  ,But when pen is up in that case
what to return (Only TouchSampleValid or TouchSampelIgnore).

Hi ppl,
        Can I use the RDEFINE Variables frm the sources.cmn file in the
registry file.
I mean

Hello CE World,
I'm using a PXA255 System with 32MB Flash and 64MB RAM. I included a
strataflash driver in my WinCE Image. It works fine in a debug image but
a release image (flash) hangs.

 Lately, I use Samsung's "SMDK2440 Evaluation Board" to try usb
Mass-storage.
First,  add some components:
1. Core Os \ Windows CE devices \ Core OS Services \ USB Host

I've want get ActiveSync working on our custom target.
The newsgroup postings I've read seem to imply that a full modem cable with
all the hardware handshaking lines is required. Unfortunately these lines
aren't even tracked from the Uart to the connector on our board. So I am I

      I am planning to use WinCe 5.0 for my school project. And I have
found some information on writing device drivers (architecture, interrupts,
memory etc) in previous versions of WinCE( WinCE 3, .net). Can these info be
applied to this new version of WinCE. what r the ...

Hi ! Every body
In My BSP package , interrupt identifier SYSINTR_TOUCH_CHANGED in not
availabel.
And we can not add anymore because interrupt idendifier list is full now

I am currently running our pxa255 based hardware at 331.8 MHz, the hardware
runs with problem and power on and off work without any problems.
I tried to crank up the speed to 398.1 MHz following the data sheet spec.
the hardware run fine but does not shut down correctly and ...

The board I'm using has two serial ports.  COM1 has full handshaking and
COM2 has none.  When I manually start repllog.exe it tries to use COM2.  I
know that this is controlled by the RAS phone book entry 'Desktop @ 19200',
but I can not find where I can change which COM ports ...

I have a strange problem. I have developed a I2C driver and currently
have the IST at same priority as app and its working ok. However when i
set the IST thread priority to say 200 i am running into problems.
Basically i have set a breakpoint in the IST on the WaitforSingleObject.

I used nand flash in our WinCE 4.2 system.
I have a FAT partition in the remaing nand flash space.
Is there any way to keep users from writing data into the FAT partition if
the free FAT space is less than 0.5 MB ?