I have a problem about the WNetAddConnection3 function. It will spend
about 4-5 sec. on its first called after system bootup. Are there any
methods to speed up this process.
Thanks

Hello;
I  can not get the serial Activesync working for my Cirrus EDB9315.
My problem is that I can not select Direct Connection from Make New
Connection.

does anyone have an alternative program to hyperterminal, which is
included in pb5.0/windowsce. a compiled program or a source code for
windows ce5.0.
thx,

I want to debug my application and device driver at the same time. I would
like to know is it possbile to debug my VS2005 application using my target
board.
My WinCE OS 5.0 device driver can be download and debug on my target boad

I realized recently that my PXA270 5.0 platform has 128MB RAM while we are
only using 64MB of it.  The 128 MB SDRAM uses 1 bank, the physical address
is contiguous.
g_oalAddressTable shows

I plan on writing an NDIS intermediate driver for Windows CE 4.2 and I can't
get kernel debugging to work.
I followed the steps in the documentation.
Since I'm not using my own OS image I just created an empty one, resetted

I have managed to compile the lan91c111 drivers supplied by SMSC and loaded
them on my target which is a samsung based arm9 board from MSC.
http://www.msc-ge.com/frame/e/produkte/inhalt_pro_ind.html
Unfortunately there seems to be a probelm when the HalTranslateBusAddress

For a reason there is not any longer possible to add Catlog listed features
from My_BSP to My_New_Platform. (It works fine for the WinCE 5.0 MinestoneII
BSP.)
What might cause this?

i have a wince 4.2 bsp which i need to migrate  in wince 5.0.I did alll
sucessfull steps as defined in wince 5.0 msdn that are necessary to migrate
,build during build and sysgen i get error as follows
BUILD: [01:0000000032:ERRORE] ceddk.def : error LNK2001: unresolved external

Its taking around 30-40min (10KB)to download 25MB nk.bin
to Karo PXA270 board over Ethernet using Redboot
bootloader which comes pre-installed. Has anyone
using this dev board come across this issue and what

I am a newbie in driver developing of WinCE. Currently, I am writing a
"Virtual COM Port to SMS" driver which creates a virtual com port and
redirects all data from com port to SMS. Simply explanation, it's a bridge
of COM and SMS, and the COM is a virtual created Serial Port.

i have installed the vcp driver for FTDI FT232BM. i tested the newly
established port with vcp driver and it worked. bytes were written and
received (loopback).
nevertheless the new port isn't established in the hyperterminal -

I am running CE5, using hive-based registry and persist registry on hard
disk. Everything works fine until I installed a new nk.bin. It seems to me a
new build nk.bin won't load the registry file stored by old nk.bin. Is that
true? How CE5 decide to give up persist registry file? ...

Our custom SH4 based hardware (CE.NET 4.2 OS) has an ST16C554 quad UART
connected. We have this working correctly using the standard
COM16550.dll driver supplied by MS (we have done some minor changes to
the PDD code in com16550.c to get it to work with our hardware, but

I am trying to debug the CF-card on our in-house development board.
Processor :- PXA270.
BSP:- MainstoneII from PB 5.0
At present, I am trying to use the CF-LAN card to download the OS image