I am testing a 3rd party WIFI device which claim itself is a 802.11g
device. Anyway I can confirm the device is running at 802.11g rather
than 802.11b etc?
Thanks very much.

For testing purposes I try to save the Hive Registry to the Release file
system on the desktop.
But so far I had no luck.
I see that the file system.hv on the desktop is being created.

I am developing a Voice IP image on WinCE5.0. When I test it on two CEPC
platforms, with no SIP server, just peer-to-peer, I am not able to connect
the SIP sessions. There is just this message - media sessions don't exist.
Can you clarify about the settings in the configuration - ...

I am using Samsung S3C2410TK board and build image by using the
SMDK2410 bsp included in PB. I have followed the manual to write the
image file to AMD flash memory with Multi-Ice. However, I found that
the board cannot boot up afterwards (The board DO work when I load the

I have some questions related to the SD and MMC card drivers under
Windows CE 5.0.
Let me first explain the behaviour that I am observing :-
The MMC card works fine without any modifications to the existing

I've created a PXA270 platform under CE 5.0.
I'm using a BSP that comes from the Mainstone II.
The Kernel works  well with KITL enabled.
If I remove the KITL checkbox and I do a Sysgen, the resulting nk.bin

I want to turn on the following DEBUGMSG in heap.c:
   DEBUGMSG(DBGFIXHP, (L"   HeapAlloc %8.8lx %8.8lx %8.8lx ==> %8.8lx\r\n",
hHeap, dwFlags, dwBytes, pitRet));
Does anybody know what the correct name of the debug zone is?

Does anyone know if this card has any chance of working on CE.NET and CE5.0?
On the website i found only the Pocket PC 2002 and 2003 drivers. Do you know
where i can get the right driver?
Many Thanks

how to know using PM.dll?
it added to registry key. i`m using default function of PM.dll but if i want
special status to operate, i don`t know how make it
regards

My icop vortex86 6071 board is too much waiting (approx. 1min) with the
debug image of winCE 5.0 at the stage:
"
RTL8139Init:: MAC = 44-4D-50-20-AC-67

I'm having troubles with integrating Intel PSM to use the P30 family of
flash chips (2 32MB parts). Our platform previously used IPSM with
J3/K3 parts (4 16MB chips), but due to supply issues, we've had to move
to the P30s.

This code causes INTERNAL COMPILER ERROR *only* when compiled with the
command

using this command does not elicit the compiler error

Do you know whether eVC++ 4.0 (ArmVI / XScale)
supports the assembly instruction  SMUL ?
That's what eVC++ says about it
"error A0051: unknown opcode: smul"

Is anyone using the logic zoom sdk?  I have the epitools majic debugger but
can't seem to get their flash tools to work.  It doesn't seem that it is
possible to debug eboot unless you can already burn it to flash.
thanks,

I guess that this is not the first time someone notices
what follows:
If i read this forum using Outlook chances are that some
post is not shown in the messages list. Perhaps are messages