I developing a touch screen driver which is working fine. But the issue I'm facing is when I open calibration screen from control panel, I can't see any cross hair, so I can't come out of it.
When I added calbration during bootup, then also I can't see cross hair and I can't able ...

i have SMDK2410+PB5.0
If KITL is enabled, everything is ok. I can download
the WINCE image to the target, debug the target and it is
also possible to access the internet with the SMDK2410 target.

I am very new at this and this boot loader thing has me very confused. I have
an image built in PB. It downloads to my target, and then I get "Jumping to
0x0013A420" on the screen and thats it. I am reading that you must create
your own bootloader. Is there no shorter way to do ...

i have 2 questions.
1. i want to get the handle of the window which is currenlty shown and
gets the user input.
i have to call getforegroundwindow() or getactivewindow()

   I have a Wince 5.0 USB FUNCTION RNDIS device with me,which I want to
interface to my PC. When I connect that device to the PC USB port I get pop
up message " new USB device found". When I follow the new device installation
wizard it ask for an "*.inf" file to locate. When I ...

Hi !
     I am workign on CPC using WincE4.2  platform builder.We are not using
Eboot rather we are using Serial boot loader.
My question is How can i suppress RETAILMSG at application level.Even if

I have problem to access my diskonchip on IntelPXA27x on CS5.
I suspect I missing some of the step to enable the CS5 slot.
Here is my step:
1. Enable CS5 and I can see the DOC using XDB debugger at CS5 address

Several of my coworkers have XP laptops with Platform Builder 5.0 installed
and are unable to ethernet download or debug CE images on our target
hardware.  Is this a known problem?  Is there a fix?
Thanks  

um....
I found PowerManager driver and migrate into my driver struct and
success a building.
here,i have a question.