I'm trying to get the PC Card working on a customized board based on
mainstoneIII.
I've some problem getting the nPREG signal. It always stays high.
From my understanding, nPREG should go low whenever it is reading the

In my understanding SD HC (High Capacity) is not supported under WinCE 5.0 at
File System & SD Bus/Host/Client driver level., am I right?
Is there any plan to support SD HC under WinCE 5.0?
Is SD HC support available under WinCE 6.0? If not is there any plan to

When copying files to the PXA270 device using Active Sync.Exception
happened:
Prefetch Abort: Thread=83981000 Proc=81ce6300 'device.exe'
AKY=00000005 PC=006d0061(device.exe+0x006c0061)

Hi experts,
we are working on wince 4.2 dbpxa255 platform. we are using intel P30
NOR strata flash 64 MB(paired flash 32MB +32MB. we are trying to
implement persistant file storage system for 2MB of flash. please find

I am migrating a Samsung BSP from WinCE 5.0 to 6.0.
Here, I am facing issues migrating the audio driver. The driver
compiled fine and the image was transferred onto the Samsung board.
Following is the entry in my .bib file:

Reference to mainstone III, may I know where is the correct location to
configure the pc-card pins?
I tried configuring the pins under xllp_pccardsocket.c, however it seems
that the configuration is not done.

I've got a development system with PB 5.0 and VS 2005. On the target board I
use a USB flash drive as the only mass storage device, the OS loads from the
on-board flash into RAM and sits there. I have enabled ROM-only FS.
I couldn't mount the USB storage at the root, so I mounted ...

I've created a CE5.0 image and in the "locale" option under platform
settings I've cleared everything and added back just "french", "english" and
"Japanese".
I happily build my image and run it. In the control panel- regional settings

I'm new to Platform Builder. I just installed Platform Builder
(WindowsMobile5\Build_14343\Magnetto_AK),
when I started the Platform Builder the first time, I encountered the
following warning message:

I've reinstalled pb4.2 and now when I tried to build a custom platform
I get the following error:
"NMAKE : fatal error U1073: don't know how to make 'C:\wince420\public
\common\oak\lib\ARMV4\retail\messagedialogboxcustomize.lib'"

My CPU is PXA270,OS is WinCE5.0.
Now my load sequence is:
1.Load SDBus.dll
registry setting is:

I am using Platform Builder 4.2 to build an OS.
I had a BSP supporting ARMV4 and I changed it to support ARMV4i. After I
built the OS I found that some settings in platform.reg are missing in the
reginit.int file.

I tried :
http://www.gotdotnet.com/workspaces/messageboard/home.aspx?id=0eb87e35-13e4-4fa3
-9fde-71e9136f47de
It does not work for the cams I have.
I cannot get the "old" quickcam 5000 pro, that does not seem to have a

Hello developers!
I would like some ideas or advices.
I'm developing a WinCE OAL, for our board with SH7760 microcontroller.
And at now, I have a big problem. WinCE loading will stop. Bootloader is ok,

Even if i remove my serial driver(ln2440sbc_serial.dll) from my OS
design i am getting
debug messages when i load OS to target device.
The following are the messages i am getting.