I am trying to install the eval verison of Platform Builder for Win CE 5.0.
The installation gets as far as updating the registry and then rolls back.
Nothing is installed and the only clue I have is that the installation has
been interrupted....

I checked the BSP from CEC editor and found that both ARMV4 and ARMV4i are
checked. It seems that the BSP supports both CPUs. Does that mean that the
OS built based on this BSP also supports both ARMV4 and ARMV4i?
I am using Platform Builder 4.2.

I have build the OS with the platfoem builder 4.2 but the library
SECUR32.DLL has need the 1.DLL. Where I find this library?
Thanks

I have two device with wince 4,2 and I thought to have the same OS but the
my softare on one works correctly and on the other it demands of the
library. Can I know the library installed on the OS ?
Thanks in advance

I am working in wince5.0
I am developing device driver.
After I added my serial driver(ser2440.dll) to my OS design OS image
is not displayed in my target device LCD.

I am trying to get my device (CEPC:x86 running CE6) and the
workstation connected via ActiveSync.
I have ActiveSync 4.5.0 installed in the workstation. I have added all
the necessary Catalog Items to the image and disabled the serial port

Can WinCE develop a L2/L3 device like switch and router , is WinCE suitable
for them ?
I've heard that between WinCE 5.0 to 6.0 , there is some pack can help to
develop  

I have a problem when building the debug version OS.
The error is the following:
Pass 2...
RAM AutoSize: RAM Start=93060000 RAM Size=fffa0000

I am completely new to Windows CE and want to learn how to write a typical
stream device driver. Can anyone tell me where to find step by step
instructions to produce the boilerplate required under PB 6.0
At the moment I would settle for a few debug messages that prove that CE

I am trying to get passive KITL working on my x86 CE 4.2 platform. I have
enabled KITL and the Kernel Debugger in my release image. The image is
loaded using TFTP and runs on my target. However I see the following in the
serial output from my target:

Can Windows ce 4.2/5.0 run on Vista?

I'm trying to develop the DirectDraw driver for CE 6.0 and in the process
and have hit a problem.
I'm getting failure messages like "GWES Hook fails to update overlay.
IDirectDrawSurface::UpdateOverlay fails." from the DirectDraw core libraries.

I am working on serial kitl reight now for our BSP,
and our EVB has two device can connect with PB,
one is ether, second is uart (has two uart port).
The ether Kitl is work fine, but when I change to serial Kitl,

      We are developing a Video telephony application which transfers
raw PCM audio data captured on one wince board (i.e intel pxa27x
development board) to the windows CE emulator on another PC which
plays back the audio .The data transfer between them is done using RTP

In WinCE Platform Builder 4.2 with undates up to March 07 installed,
the following code misbehaves...
for (...)
{