I tried to run the One-Card Network Card Miniport Driver Test on WinCE 5.0
CETK but faced one problem that the CETK server will be disconnected with
the target device every time while the 1c_SuspendResume test is running to
the point as descibed below. Because the CETK server is ...

Any light on this problem would be much appreciated!
-------------------
I have a fairly large project that uses C++ partial templates. This
works fine to build with CE5. However, it seems like prefast doesn't

Hi, all,
Does anyone here know Mobility ToolKit (Mtk)? Where can I find the
information about it?
Thanks.

I have not found any documentation on running this test so far.  When I
right click on the test itself in the CETK GUI the "Test Information"
option is greyed out.  I have tried plugging in a variety of USB Host
devices when the test indicates but it skips all 52 tests.  Is there

I'm trying to test my serial driver in CE using the Serial Port Driver
Test.  I'm guessing that I need to specify the COM port that I want to
test?
tux -o -d serdrvbvt -c "-p COM2:"

For a newbie to CETK I have to run the File System Driver Test to get
my BSP certified.  However I've been unable to run it as yet.  The
storage device that I'm going to test is a CF card named "Storage Card"
on my device.  These are the command line arguments that I'm passing to

I think I did something stupid and now I don't know how to reverse it.
I disabled a few services on my system to help performance on my PC.
After disabling some of these I ran CETK to test a BSP I'm developing.
Whenever I try to run a test the CETK program on PC crashes and never

Hi,
While deploying using Active Sync 3.7.1, I am receiving the follwing error:
------ Deploy started: Project: Interfaces, Configuration: Debug Pocket PC
------

In the "New Project Wizard (WCE TUX Dynamic-Link
Library)", how can I specify the DLL to be Release or
Debug build? (and change it later one.)
Or, I do not need to, it will be something inhered from

I bootup/download image my CEPC from Platform Builder,
through Ethernet. But I can not get the IP of my CEPC.
Here is what I did:
From "Target Device Connections" -> "Kernel Service Map" -

I did a Bluetooth Client/Server test recently. I found client can't connect
to the server no matter how hard I tried.
I used two windows mobile 2003 devices, and turned on both to be
"Discoverable Mode". I renamed one of them "BTServer", after that I start